Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Audio Cables & Interconnects
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Audio Cables & Interconnects
This little crossover is great. Used it with a 6.5" woofer rated at 50 watts and a matching tweeter. Previously the tweeter was capped and the woofer was running full range. This crossover improved the sound *dramatically* at higher volumes, eliminating the breakup from the woofer. Much smoother and clearer at full volume. Sounds GREAT! Now, some extra documentation. The documentation on the listing is not super clear or complete. Here's some additional info to clarify how these work. A and B control filtering on the woofer; C and D control filtering on the tweeter. With A and B in place, the woofer runs full range. Remove A to get a high-pass filter at about 100hz (not sure the slope). Remove B to get a low-pass filter on the woofer at 4kHz. On the tweeter side, with C in place but not D, the tweeter is high-pass at 4kHz. So, the "standard" setting of A + C gives you a crossover at 4kHz (again, not sure the slope). C + D sets the tweeter high-pass at 2.5kHz D only sets the tweeter high-pass at 8kHz or so If you remove both C and D, the tweeter is muted. Enjoy!Read full review
Verified purchase: Yes | Condition: New
Verified purchase: Yes | Condition: New
Thanks
Verified purchase: Yes | Condition: New